LED & LED Displays
> USB to TTL Debug Cable for Raspberry Pi
Raspberry Pi USB Debug Cable
USB to TTL Debug Cable for Raspberry Pi
Integrated Serial conversion chip on cable
Ideal for Raspberry Pi
Put me on the Waiting List
Add to Cart
Review this item
Add to Wish List
Email a friend
The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.
Because of the separated pin plugs, this cable is ideal for powering and connecting up to the debug/login console on the Raspberry Pi. Connect the pins as shown to power the Pi and establish the RX/TX link. Then install the
PL2303HX.D drivers on your computer and connect with a terminal program at 115200 baud.
Also handy for hacking WiFi routers to install alternate OS's, or nearly any other TTL port. This is easier to use than an FTDI cable in many cases because the wires are separated
This cable is
good for Arduino re-programming
such as a Boarduino, MENTA, Monochron, etc. because it does not have the DTR/RTS wire necessary for initiating the bootloader reboot sequence.
Raspberry Pi Starter Kit w/Raspberry Pi - (R-PSK)
Raspberry Pi to Breadboard Adapter Kit
Recently Viewed Items
Browse Similar Items